Rear Panel Connectors - BEC 9900VA Quick Start Manual

Rear Panel Connectors

INTERFACE
Wi-Fi Antenna
1
Connectors
2 Power
Power Jack
3
(DC IN)
4 SFP
Gigabit Ethernet
5
(LAN 1 - 3)
6 USB
7 Reset
8
WPS &
Wi-Fi On/Off
9 FXS Ports (1-2)
3
BEC 9900VA Active Ethernet Fiber 802.11ac Gateway with VoIP
Female RP-SMA connectors, total of 6.
Manually screw the dual-band Wi-Fi antennas tight to each connector.
Power on/off button.
Connect the supplied power adapter to this jack.
Insert and gently push a 1000Base SFP module until it snaps into the slot tightly.
Connect an Ethernet cable (Cat-5 or Cat-5e) to one of the LAN ports with a 10Mbps
/100Mbps /1000Mbps PC or an office/home network device.
* 1/EWAN
Connect to Fiber/ Cable/ xDSL Modem with a RJ-45 cable for broadband connectivity.
Note: LAN 1 automatically becomes an EWAN port when ETH WAN interface is selected
and configured in the GUI.
Connect with a USB hard drive for storage/file sharing.
After the device is powered on, press it 6 seconds or above: to restore to factory
default settings (this is used when you cannot login to the router, e.g. forgot your
password).
By controlling the pressing time, users can achieve two different effects:
*
(1) WPS : Press &hold the button for 2 seconds to trigger WPS function.
(2) Wireless ON/OFF button: Press & hold the button for more than 6 seconds to turn
on/off the wireless.
* For WPS configuration, please refer to the WPS section in the User Manual.
Connect your analog phone(s) to the FXS port(s) with RJ-11 cable(s).
MEANING