Table of Contents
Advertisement
4
–(b)
– – (b)
3
5
6
7
–(a)
– – (a)
ZR-RX40 Start Up Guide
3
Select [TC-T] for the [Range] parameter for CH 1 and CH 2.
(a) Move the cursor to the [Range] parameter opposite
CH 1 and select [TC-T].
(b) Make the same setting for CH2.
4
Select "Off" for all the other channels.
(a) Using the procedure described above, select [Off] for
CH 3 to CH 10.
(b) Use the CH GROUP key to switch to the CH11 to
CH20 group.
5
Press the MENU key and open the [DATA] menu.
6
Set the sampling interval to [1s].
Move the cursor to [Sampling] and then select [1s].
7
Specify the Capture Destination file name.
Here we will create a folder named [TEST] in the USB
memory device, and then make the settings required to
enable data to be captured to the TEST folder.
(a) Move the cursor to the File Name parameter and
then press the ENTER key.
(b) With the cursor on the [<MEM>] item in the following
screen, press the ENTER key.
(c) The file settings box shown in the following screen
opens.
This box is used to specify file names for the ZR-
RX40's internal memory and for the USB memory
device.
2. Setup: Setting the Temperature Measurement
33
Advertisement
Table of Contents
