Table of Contents
Advertisement
4
MENU key
Press the MENU key to open a setup menu. Each time this key is pressed, the setup screen tabs change
in the sequence shown below.
AMP
DATA
TRG
USER
I/F
OTHR
QUIT (LOCAL) key
5
Press the QUIT key to cancel the settings and return them to their default status. If the device is in the
Remote (Key Lock) status, namely the external operating status via the interface, press this key to return
the device to the normal operating status (Local).
6
keys (DIRECTION KEYS) key
These keys are used to select menu setup items, to make span settings in the digital display area, to
move the cursors during a data replay operation, and so forth.
7
ENTER key
Press the ENTER key to enter the settings made in the setup menus, and to confirm your settings.
8
keys (KEY LOCK)
These keys are used to move the cursor at high speed during a data replay operation, and to change the
operation mode in the file settings box. Hold down both keys simultaneously for at least two seconds to
enable key lock status. To cancel key lock status, press them again for at least two seconds. The key lock
status can be confirmed by the status of the key lock lamp on the monitor.
START/STOP (USB DRIVE) key
9
Press the START/STOP key to perform a data capture start operation while the ZR-RX40 is in the Free
Running status, and a data capture stop operation when data capture has ended. If this key is held down
while the power to the ZR-RX40 is turned on, the ZR-RX40 goes into USB Drive Mode.
10
REVIEW key
Press the REVIEW key to perform a data capture start operation while the ZR-RX40 is in the Free
Running status, and a data capture stop operation when data capture has ended. If this key is held down
Note: while the power to the ZR-RX40 is turned on, the ZR-RX40 goes into USB Drive Mode.
A data replay operation will not be performed if data has not been captured.
24
Descriptions of the Control Panel Keys
• AMP Settings
Used to make the input, range, filter and other settings.
• Data Capture Settings
Used to make settings such as the sampling interval, data capture
destination, and calculations during data capture.
• Trigger Settings
Used to specify the data capture start and stop conditions, and the alarm
conditions.
• User Settings
Used to set the names of the users of this device, and to change from one
user to another.
• Interface Settings
Used to set USB ID numbers and LAN IP addresses.
• Other Settings
Used to make settings such as screen brightness and AC frequency.
ZR-RX40 Start Up Guide
Advertisement
Table of Contents
