Table of Contents
Advertisement
SAND FILTER INSTRUCTION MANUAL
Filter parts installation
Carefully remove all components from the package and check that nothing is damaged. If the device is damaged, immediately
contact the retailer where the purchase was made.
1.
Insert the tube with the manifold into the container (drawing 2) and screw the small sand guard filters to the manifold
(drawing 3).
2.
Place the completed manifold on the foundation and fill halfway with water to stabilize it. Make sure that the star-shaped
gauze is well centralized in the bottom of the filter and that the purge screw is tight.
3.
Place the spigot on the mouth of the container, making sure the tube is centered on the manifold.
4.
Fill the filter with sand to 3/4 in height (ideal sand grain size: 0,7 - 1,2 mm; quantity: according to the filter size) (drawing
4).
5.
Now, put the upper part of the filter or valve as well as the joint on the upper edge of the filter. The connection between
the upper part of the filter or valve is made with the collar. The collar is secured with a screw and a nut (see drawings 5
and 6).
Finally, put the pieces to connect the filter to the valve. Make the joints watertight with PTFE tape.
www.cpa-piscine.it
Drawing 2
Drawing 4
Drawing 3
Drawing 5
Drawing 6
pag. 4 di 8
Rev.01–26/04/21
Advertisement
Table of Contents
