Fixing The Leaf Skimmer; Phase 3 - Filling The Pool With Water - C.P.A. White Pool 490 Assembly And Maintenance Manual

WHITE POOL INSTRUCTION MANUAL
Vertical support
Check for damaged support
and replaced where necessary
XV.

Fixing the leaf skimmer

To prevent rust, all edges of cut out have to be covered by vinyl tape or rusting paint. Begin the installation of the through the wall
skimmer. Follow separate skimmer installations.
PHASE 3 – Filling the pool with water
Before you fill the pool with water, thoroughly check to see if there are any loose screws, holes or tears in the liner. Fill the pool
until it is half-way across the skimmer box opening or to the maximum water level or a minimum of 15cm (6") from the top of the
pool wall (see diagram 43) to make sure water is entering the skimmer box opening.
To avoid collapse, never leave the pool without water in it.
The filter pump must be switched off if there are swimmers inside the pool! Follow assembly instructions in the sand filter pump
combo manual.
www.cpa-piscine.it
Upper joint protector
Check for damaged for
broken protectos and
replace where necessary
Side top platform
Check for damaged for broken platforms
Top and bottom rails and repair where necessary
Check to make sure the pool
wall is placed firmly in between
the upper and lower rails
Top and bottom
metal piece
Check for loose
connections and tighten
screws and bolts
Pool liner
Check for rips tears holes
and repair where necessary
Diagram 42
WARNING
Diagram 43
WARNING
pag. 28 / 29
Top platform
Check for damaged for
broken platforms repair
where necessary
Rev.00–16/10/20