Table of Contents
Advertisement
AD5500
Tour
Select the Tour button to bring up the AD Monitor Tour
dialog box, illustrated below. This dialog box allows the
user to run a Monitor or System Tour.
All tours must be programmed by the AD Matrix Switcher
before being run from this dialog box. For information
about programming Monitor and System Tours, refer to the
appropriate Switching System Programming manual.
To run a pre-programmed tour:
1. Select the desired Matrix Switcher using the check
boxes at the right side of the dialog box.
2. Select either the "Monitor Tour" or "System Tour"
check box at the top middle of the dialog box.
3. Enter a Monitor number using the keypad on the left.
4. Select the "Monitor" button in the middle.
For a Monitor Tour:
5. Select "Run" to start the current Monitor Tour.
For a System Tour:
5. Enter a System Tour number with the keypad.
6. Select the "Sys Tour" button to start the System Tour.
While a tour is running, select "Hold" at the bottom of the
dialog box to stop the tour, "Next" to step through the
cameras in the tour, "Last" to step backwards through the
cameras, and "Run" to restart the tour from a Hold.
To exit the Monitor Tour dialog box, select "Cancel". If a
tour has been started, it will continue running after the
dialog box is closed.
Mon-A ... Mon-D
The four Mon buttons on the button bar select the alternate
monitors defined by the Define Alternate Monitors menu,
page 2-6. If alternate monitors have not been defined, a
warning message is displayed when Excalibur is opened
(page 2-7). This indicates that the four Mon buttons cannot
be used until they are defined.
When Excalibur is started, the alternate Mon buttons are
disabled. To enable them, select the Operator Preferences
menu, page 2-6, and set the "Enable Alt. Monitors" option.
To call a camera to an alternate monitor:
1. Ensure that Alternate Monitors are both Defined and
Enabled.
2. Select the desired alternate monitor button.
3. Select the desired camera icon.
The camera is then called to the alternate monitor, instead
of to the monitor defined by the icon setup program.
To use the regular monitor assigned to the camera icon,
select "Cancel" (see below) before selecting the desired
camera icon.
Cancel
Select the Cancel button at the right of the button bar to
cancel Control, Shunt, and alternate monitor actions.
2-9
EXCALIBUR
Advertisement
Table of Contents
