Westfalia 82 29 60 Instruction Manual page 10

 Do not replace the power cord and do not repair it. It is not allowed to modify
the power cord by installing a switch or similar.
 Do not pull the power cord around sharp edges or corners. Do not pinch or
crimp the power cord in any way. Keep the power cord away from hot
surfaces. Make sure the cord cannot become a tripping hazard.
 Make sure the power cord is not rolled during operation.
 Do not use the power cord to carry or transport the pump.
 If not in use, do not hang up the pump on its power cord.
 In case of power failure, disconnect the pump from power mains by pulling the
power plug.
 Protect the pump from frost.
 Make sure that the ground wire (yellow/green) is not interrupted neither in the
power line, in an eventually connected extension line, nor in/at the device,
since an interrupted ground wire represents a danger to life!
 When using extension cables, make sure that plug and sockets are splash
water-safe.
 Protect the pump from running dry. Running dry will occur if the pump is
operated without water in the housing.
 Protect all electric connections from water. In areas exposed to a risk of
flooding, install all connectors in flood-safe areas. Do not immerse the whole
pump into water.
 Operate the pump only in conjunction with a residual-current-operated
protective device (RCD) with a residual current rating lower than 30 mA (for
example Westfalia Art. 66 72 61).
 Disconnect the pump from power mains if you clean or do not use it for a long
period of time.
 If the pump itself or the power cord become damaged, do not operate the
pump furthermore and have it repaired by a professional or contact the
Westfalia customer service. Do not disassemble the unit or try to repair it
yourself.
Safety Notes
5