Safety Rules - ABB TruFit User Manual

1.2

Safety rules

Save these instructions!
The power distribution unit operates with high currents and voltages. The properly installed system is
grounded to earth and IP 20 rated against electrical shock and foreign objects when all dead fronts are in
place. Installation and service must be performed by a manufacturer's qualified technicians or a certified
service partner.
General
- Move the PDU in an upright position in its original package to the final destination room.
To lift the cabinets, use a forklift or lifting belts with spreader bars.
- Check for sufficient floor and elevator loading capacity.
- Check the integrity of the PDU equipment carefully.
If you notice visible damage, do not install or start the PDU.
Contact your ABB Service Center immediately.
- WARNING! RISK OF ELECTRICAL SHOCK!
Do not remove covers, there are no user serviceable parts inside.
This should be performed by qualified service personnel.
- This PDU contains potentially hazardous voltages.
- End user must follow applicable regional occupational safety codes/regulations during installation,
operation and equipment maintenance. This may require additional field marking or labelling defining
appropriate level of PPE (Personal Protection Equipment) to reduce the risk of Arc-flash related injuries.
Contact our ABB Service Center for product specific information.
ARC FLASH HAZARD SYMBOL
Indicates the presence of an arc flash hazard.
IMPORTANT INFORMATION SYMBOL
This symbol indicates operator tips and/or important
information for the use of the product. This symbol is not used
to indicate information regarding potential hazards or property
damage.
RECYCLE SYMBOL
DO NOT DISCARD SYMBOL
Indicates that you should not discard waste electrical or
electronic equipment (WEEE) in the trash. For proper disposal,
contact your local recycling/reuse or hazardous waste center.
Power Distribution Unit│94-1100-00002874 A0 EN 5
TruFit™