Techly IDATA VGA-WL200 User Manual page 10

EN
CONNECTION
PC
Connection instruction:
1) Connect VGA input with VGA source device and connect audio
cable with audio IN interface of the sender (TX).
2) Connect VGA output with VGA display device and connect audio
cable with audio OUT interface.
3) Power on the device (power led lights) and it works.
FAq
q: TV display "Waiting for connection" on the right corner?
A: Please check if the power supply of TX (Sender) and switcher (if
used) is connected, and make sure connecting cable is firmly.
q: T V display "Please check the TX input signal" ?
A: 1) Please check if there is a VGA signal input of TX.
2) Try to connect the signal source directly to display device to see
if there is signal output from source device or change the signal
source, VGA cables and try again.
q: Display not fluent, not stable?
A: 1) Please move the position of the sender (TX) and receiver (RX)
and make sure the device is within the required signal range.
2) Click the "reset" button on the TX/RX panel, reset and
reconnect.
3) Remove other wireless signal disturbance and reduce the
obstacles on the way.
10
HDMI EXTENDER TX
VGA IN
Audio IN
VGA WIRELESS EXTENDER
SENDER
Audio OUT
HDMI EXTENDER RX
RECEIVER
VGA OUT
TV