Degree Of Water Hardness; Test Run - Hanseatic HGTI6082C147735TS User Manual

Degree of water hardness

Determine water hardness
In order to determine the water hardness in
your place of residence, you can
– look on the website of your water provider.
– telephone your water supplier.
– purchase suitable test strips at the phar-
macy.
Degree of household
water hardness
0–5 °dH
6–11 °dH
12–17 °dH
18–22 °dH
23–34 °dH
35–55 °dH
1. Obtain the appropriate setting from the
table above.
2. Close the dishwasher door.
3. If the dishwasher is switched on, touch
the sensor (1) to switch it off.
Adjusting the water hardness level
Do not allow more than 1 minute to elapse
between the following steps, otherwise the
setting process will be interrupted.
1. Switch the dishwasher on using the
sensor (1).
2. Touch the P sensor (2) for slightly longer
than 5 seconds until the
flashes, and the display shows the degree
of water hardness that was last used.
3. Touch the P sensor (2) until the desired
setting is displayed.
4. To save the setting, touch the
or wait approx. 5 seconds until the dish-
washer automatically returns to the nor-
mal display.
The hardness level setting is saved.
Set-up, connection and initial start-up

Test run

It is recommended that you carry out a test
run before the first dishwasher cycle in order
to remove residues from the manufacturing
process and in order to ensure that the appli-
ance functions perfectly.
If no water escapes during the test run and if
there are no unusual noises, the appliance is
ready to use.
Carry out this test run when the dishwasher is
Correct
empty and without any dishwasher detergent.
setting
See chapter "Operation" from page EN-22 for
H1
the procedure.
H2
H3
H4
H5
H6
indicator (18)
sensor,
Page EN-35