Connect The Inlet Hose - Hanseatic HGTI6082C147735TS User Manual

Page EN-30 Set-up, connection and initial start-up
You can connect the end of the outlet hose in
two different ways:
– Connection to a floor drain.
– Direct connection to the odour seal (si-
phon) of your washing/dishwashing basin.
Technical measures are required for this.
For this reason, only plumbing experts or
members of our service team may connect
the outlet hose (see page EN-40). The out-
let hose must be a maximum of 1000 mm
above the floor.

Connect the inlet hose

NOTICE
Risk of damage!
The appliance is designed for a wa-
ter pressure of 0.4 to 10 bar (0.04 to
1.00 MPa). Water must always be able
to run freely into the dishwasher, oth-
erwise this can damage the appliance.
If the water pressure is higher than
■
this, install a pressure reducer. If in
doubt, enquire about the water pres-
sure with the water supply company.
Never connect the appliance to the
■
water tap or the mixing arm of a wa-
ter heater (continuous flow heater,
pressure-free boiler etc.).
Ø ≥ 40 mm
Ensure that the inlet hose is not
■
kinked and is carefully connected.
Do not cut through the inlet hose.
■
It contains electrical components. If
the inlet hose is damaged, have it re-
paired by a specialist ("Service" see
page EN-40).
Do not use old or previously installed
■
inlet hoses.
3
¾ inch
Inlet hose
For water supply, you need a water tap with
a ¾ inch screw connector.
1. Screw the safety valve's lock nut to the
tap hand-tight.
2. Check that the connection to the water
tap is sealed. Turn on the water tap slow-
ly and ensure that no water is escaping.
Then close the tap again.