Setting The Date Format - American Dynamics ADTTE Operation And Programming Manual

Using matrix switcher with adtte keyboard controller

Hide thumbs Also See for ADTTE:

Operator's manual (51 pages)

Operation and programming manual (31 pages)

Installation instructions (4 pages)

Table Of Contents

Table of Contents

Enlarged version

Display / Queuing /

Clearance

Block / Hold / Auto

Block / Hold / Manual

Dual / Hold / Instant

Dual / Sequence / Instant

Dual / Hold / Auto

Dual / Sequence / Auto

Dual / Hold / Manual

Dual / Sequence / Manual

Disarm Monitor

Enable Manual Override

Disable Manual Override

Display Arming Status

IMPORTANT!

If a dual display code [13-15] is

selected, the second (sequence) monitor is

automatically selected after the first (hold) monitor is

armed. The sequence monitor number will always

equal the hold monitor number + 1.

Note:

Verify that the keyboard is in programming

mode before performing this task. See Unlock/Lock

the Keyboard on page 14.

To arm a monitor:

1. Call the monitor to be armed.

Note:

To display the current arming status, enter

0, and press Mon Arm On.

2. Select the desired arming code from Table 6.

3. Enter the command number (1-18), and press

Mon Arm On. The code letters will be displayed

for five seconds in the on-screen status line.

Note:

Selecting a monitor (1-16), and pressing Mon

Arm On. This activates the arming method

designated by using the Monitor menu (page 27).

Option for Manual Override

Any monitor assigned for instant or auto clearance

can be additionally enabled for manual override.

Note:

Verify that the keyboard is in programming

mode before performing this task. See Unlock/Lock

the Keyboard on page 14.

To enable or disable manual override:

1. Call the desired armed monitor.

2. Do one of the following:

Command

17-Mon Arm On

18- Mon Arm On Disable manual override

Any monitor armed for manual clearance will display

a four-letter code acronym with "A" (acknowledge)

as its fourth or right-most code letter.

MEGAPOWER 48 / ADTTE

OPERATION AND PROGRAMMING REFERENCE GUIDE

Code

Command

BHA

11-Mon Arm On

BHM

12-Mon Arm On

DHI

13-Mon Arm On

DSI

DHA

14-Mon Arm On

DSA

15-Mon Arm On

DHM

DSM

16-Mon Arm On

or Mon Arm Off

17-Mon Arm On

18-Mon Arm On

0-Mon Arm On

Function

Enable manual override

Disarming a Monitor

Note:

Verify that the keyboard is in programming

mode before performing this task. See Unlock/Lock

the Keyboard on page 14.

1. Clear all currently active alarms.

2. Select the monitor you want to disarm (1-16).

3. Press Mon Arm Off.

Note:

You can also disarm a monitor using the

arming code. Select the monitor you want to disarm,

enter 16 and press Mon Arm On.

Resetting the System

WARNING:

all programmed information about the

system. Before performing this task,

backup your settings using the S3

software.

To clear all previously programmed information, and

reset the system to its original default settings,

perform a system reset.

Note:

Verify that the keyboard is in programming

mode before performing this task. See Unlock/Lock

the Keyboard on page 14.

1. Enter 55 and press F2.

2. Enter 99 and press F2.

Note:

Step 2 must be performed within 3 seconds of

performing step 1 or the reset will not occur.