Table of Contents
Advertisement
The electronics must be connected to the primary part by aligning the 2 red points on each connector.
Take care not to force the connectors together: check the correct aligning of the 2 red points.
Fix the flexible sheath to the machine. Take care not to fix the sheath to parts heated at over than
220°C.
Screw the electrical cable connector to the electronics and switch on the sensor.
Wait 60 seconds before starting to operate the transducer.
To disconnect the electronics from the primary sensor, take care to handle the two connectors next to the
red points and not to force the disconnection.
Remark:
In modular versions the decoupling between the electronics and the primary element is not
allowed.
8
3c - Connecting amplifier (only for modular versions)
80175G_MAN_I3-IE-IN-IX_I7_11-2018_ENG
Advertisement
Table of Contents
