Function And Control; Remote Control Operations; Buttons On Remote Controller; Icon Display On Remote Controller - Gree ETAC2-07HC230VA-A Service Manual

Service Manual

6. Function and Control

6.1 Remote Control Operations

Buttons on Remote Controller

Icon Display on Remote Controller

Operation introduction of remote controller
Note:
When power is connected(stand by condition), you can operate the air conditioner through the remote controller.
When unit is on, each time you press the button on remote controller, the sending signal icon
will blink once. If the air conditioner gives out a beep sound, it means the signal has been sent.
When unit is off, set temperature will be displayed on the remote controller(If the light of indoor unit display is turned on, the
corresponding icon will be displayed); When unit is on, it will display the icon of the on-going function.
1. ON/OFF Button
Press this button to turn unit on/off.
2. MODE Button
Pressing this button once can select your required mode circularly as below(the corresponding icon
selected):
Technical Information
T-ON T-OFF
AUTO
SWING
COOL
SLEEP
DRY
LOCK
FAN
SPEED
HEAT
MODE
ON/OFF
_
+
FAN SWING
SLEEP
TIMER
Timer on Timer off
For auto operation
AUTO
For cooling
COOL
For drying
DRY
For fan only
FAN
For heating
HEAT
Set temperature
AUTO
T-ON T-OFF
SWING
SLEEP
LOCK
SPEED
COOL DRY FAN
ON/OFF button
MODE button
+/- botton
FAN button
SWING button
SLEEP button
TIMER button
Sending signal
For air swing
For sleeping
For locking
For setting fan speed
Set time
on the display of remote controller
will be lit up after the mode is
HEAT(For cooling and heating model)
25