Important Safety Instructions - Bosch AUTODOME IP starlight 5100i IR Installation Manual

AUTODOME IP starlight 5100i IR
1.4

Important safety instructions

Read, follow, and retain for future reference all of the following safety instructions. Follow all
warnings before operating the device.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10. Protect all connection cables from possible damage, particularly at connection points.
Caution!
TO REDUCE THE RISK OF ELECTRIC SHOCK, DISCONNECT THE POWER SOURCE WHILE
!
INSTALLING THE DEVICE.
Caution!
Installation must be made by qualified personnel and conform to ANSI/NFPA 70 (the National
!
Electrical Code
and all applicable local codes. Bosch Security Systems accepts no liability for any damages or
losses caused by incorrect or improper installation.
Warning!
Risk of bodily injury, property damage, or damage to the unit
!
Because of the weight of the camera, do not use the optional extension pipe (NDA-U-PMTE)
to extend the pipe while using the pipe mount (NDA-U-PMT or NDA-U-PMTS).
All-pole power switch - Incorporate an all-pole power switch, with a contact separation of at
least 3 mm, into the electrical installation of the building. If it is needed to open the housing,
use this all-pole switch as the main disconnect device for switching off the voltage to the unit.
Camera signal - Protect the cable with a primary protector if the camera signal is beyond 140
feet, in accordance with NEC800 (CEC Section 60).
Fuse rating - For security protection of the device, the branch circuit protection must be
secured with a maximum fuse rating of 16A. This must be in accordance with NEC800 (CEC
Section 60).
Ventilation – Any openings in the device / enclosure are provided for ventilation to prevent
overheating and to ensure reliable operation. Do not block or cover these openings. Do not
place the device in an enclosure unless proper ventilation is provided, or the manufacturer's
instructions have been adhered to.
Outdoor signals - The installation for outdoor signals, especially regarding clearance from
power and lightning conductors and transient protection, must be in accordance with NEC725
and NEC800 (CEC Rule 16-224 and CEC Section 60).
Power disconnect - When PoE (802.3bt) supplies power to the unit, the Ethernet cable is the
main device to disconnect power for all units.
Bosch Security Systems
Clean only with a dry cloth. Do not use liquid cleaners or aerosol cleaners.
Do not install device near any heat sources such as radiators, heaters, stoves, or other
equipment (including amplifiers) that produce heat.
Never spill liquid of any kind on the device.
Take precautions to protect the device from power and lightning surges.
Adjust only those controls specified in the operating instructions.
Operate the device only from the type of power source indicated on the label.
Unless qualified, do not attempt to service a damaged device yourself. Refer all servicing
to qualified service personnel.
Install in accordance with the manufacturer's instructions in accordance with applicable
local codes.
Use only attachments/accessories specified by the manufacturer.
®
(NEC)), Canadian Electrical Code, Part I (also called CE Code or CSA C22.1),
Installation Manual
Safety | en 5
2021-02-19 | 0.7 |