Advertisement
Quick Links
Quadratec
for use with Rubicon Rails
Installation Manual for '07- 18 JK 2 & 4 Door Wrangler Vehicles
Rock Sliders
®
#
12004.3220 &
#
12004.3221
For
Door JK
For
Door JK
TO REDUCE RISK OF SERIOUS INJURY OR PROPERTY DAMAGE:
READ ALL SAFETY MESSAGES AND UNDERSTAND ALL INSTRUC-
TIONS AND PROCEDURE NOTI ES BEFORE ATTEMPTING TO
INSTALL OR USE THIS PRODUCT. FOLLOW ALL INSTRUCTIONS
AND WARNINGS WITH PRODUCT & VEHICLE OWNERS MANUAL.
THIS PRODUCT IS INTENDED TO REDUCE RISK OF OFF-ROAD
BODY PANEL DAMAGE AND ASSIST IN ENTRY/EXIT FROM
VEHICLE. YOUR TUBE STEP IS NOT INTENDED TO INCREASE
OCCUPANT PROTECTION OR REDUCE VEHICLE DAMAGE IN
EVENT OF ACCIDENT.
PROPERLY TORQUE AND RECHECK FASTENERS AND SECURITY
OF STEP TREAD AFTER 250 MILES AND FREQUENTLY THERE-
AFTER. INSPECT AND DO NOT USE IF DAMAGED.
DO NOT USE TUBE STEP AS WINCH/SELF-RECOVERY
ATTACHMENT POINT.
CHECK STATE AND LOCAL HIGHWAY SAFETY LAWS REGARDING
PERMITTED ON-ROAD EQUIPMENT.
The Trusted Source
For 4 Door JKU
For 4 Door JKU
Advertisement
Related Manuals for Quadratec Rock Sliders
Summary of Contents for Quadratec Rock Sliders
- Page 1 Quadratec Rock Sliders ® for use with Rubicon Rails Installation Manual for ’07- 18 JK 2 & 4 Door Wrangler Vehicles 12004.3220 & 12004.3221 Door JK For 4 Door JKU Door JK For 4 Door JKU TO REDUCE RISK OF SERIOUS INJURY OR PROPERTY DAMAGE:...
- Page 2 Careful attention is required to this instruction or operation but does ® generally not relate to personal injury. Damage to your Quadratec product or other property may result if you don’t follow instructions. Due to the length and bulk of these...
- Page 3 Driver Side 4 Door You can identify the left and right hand pieces by locating the Quadratec oval logo. The logo should be at the front of the part. Sidebars and Rocker Guards tend to be heavy. We recommend getting assistance from another person when it is time to lift and position your rocker guards.
- Page 4 Reinstall the factory nuts on to the studs and over the rock sliders. Tighten with a 16mm deep socket and ratchet. After reinstalling all of the factory nuts, torque them to 40 ft lbs.
- Page 5 Product Care and Maintenance: Your Rock Sliders have been designed subject to potential rock chips and other and manufactured to provide years of debris potentially causing portions of use. However, like any product, general the paint to chip off. For touch ups, we...
- Page 6 Quadratec to obtain a RGA number only to Quadratec branded accessories first sold (610-701-3336). All labor, removal, shipping in the United States, Quadratec warrants to the and installation costs are customer’s initial retail purchaser only that your responsibility.