Angle wrench, in-line and push-to-start dc electric tools (52 pages)
Summary of Contents for Ingersoll-Rand D Series
Page 1
16574238 Edition 2 May 2014 Air Percussive Chipping Hammer “D” Series and MDT3-EU Maintenance Information Save These Instructions...
Page 2
Product Safety Information WARNING Failure to observe the following warnings, and to avoid these potentially hazardous situations, could result in death or serious • injury. • Read and understand this and all other supplied manuals before installing, operating, repairing, maintaining, changing accessories on, or working near this product.
Page 3
(9). Coat the threads of the Inlet Bushing with a suitable thread NOTICE locking compound. Tighten the Bushing to a torque of 35 ft/lbs (47 Nm). The 19 mm Hex Nozzle is fully home when it is approximately NOTICE 7 mm (0.750”) below the end surface of the Barrel. Over-tightening of the Bushing may cause stripping of the NOTICE Bushing threads in the Handle.
Need help?
Do you have a question about the D Series and is the answer not in the manual?
Questions and answers