Advertisement
FINAL INSTALLATION
Turn on power to fan at breaker box and the wail switch.
Assembly
is complete.
2
>
v Motor Screw
—
=)
Light Pan
Fitter Plate &
Screw
'
9-pin
@ Light Pan
'
Connector
Screw
Figure 4.4
Figure 4.5
Figure 4.6
3
Mounting
Screw
|
|
|
Battery
|
-—
fc
Glass Assembly
(
——
Wall Bracket
Figure 4.7
Figure 4.8
Figure 49
OPERATING INSTRUCTIONS
1. To operate the fan using the remote, press and retease the following buttons (Figure 5.1)
A - Fan Off - Turns the power to fan off.
B - High Speed - Turns on fan at high speed
C - Medium Speed - Turns on fan at medium speed.
D - Low Speed - Turns on fan at low speed
E - Light Delay - Light Control: Dimmable Bulbs - Press light control to turn lights off and on. Press
and hold light control
to dim or brighten the lights. Non-dimmable Bulbs -Turns the lights on and off. Note: The dimmer
function does not work
with non-dimmable bulbs
F - Light Delay Off mode - Press and hold the fan power button for five seconds,
which will turn off light after one minute.
The LED indicator on the remote will flash four times to confirm mode setting
G- Variable Breeze - Simulates a breeze in nature. Press and hold button to activate
Press any fan speed button to cancel
H - Home Shield™ - Simulates occupancy while away from home. Fan remains off and
the light randomly turns on fora
minimum of five times and a maximum of 20 minutes. The light remains off for 60
minutes between events. Press and
hold button to activate. Light will blink twice to confirm Home Sheild is active
Press any button to cancel
| - LED indicator - should illuminate when any remote button is pressed. If not, replace the DC3V, CR2032 batteries.
J - LEARN button - Syncs remote to receiver (see TROUBLESHOOTING for instructions). Note:
To access LEARN button
remove battery door from back of the remote using a flat-head screwdriver.
| Reverse Switch
Remove glass assembly by turning in a counter
clockwise direction to access the reverse switch.
Figure 5.1
=
Figure 5.2
Advertisement
