Table of Contents
Advertisement
SECONDARY HANGING SYSTEM INSTRUCTIONS
For installation in the United States: Building codes in the U.S.A. do not require installation of a Secondary Hanging System.
If desired, the braided cable can be cut and removed using wire cutters (sold separately). Skip to FINAL INSTALLATION. For
installation in Canada: In compliance with building codes in Canada, installation of the Secondary Hanging System is required.
1. WARNING: Secondary support is required for this product. Failure to follow the steps below could result in property damage
and/or personal injury. Feed the loop of the braided cable, preassembled to the motor assembly, up through the outlet box
mounted in the ceiling (Figure 3.1).
2. Install secondary support screw, spring washer and support washer partly into the side of the brace installed in the ceiling.
Then loop the braided cable up and over the ceiling brace and place the open loop of the braided cable around the secondary
support screw. Note: The ceiling support brace may not be accessible from below. If not, it must be accessed from above.
Important: The braided cable must make a complete circle around the support brace to secure the fan (Figure 3.2).
3. Tighten the secondary support screw, securing the braided cable (Figure 3.3).
Brace
Figure 3.1
FINAL INSTALLATION
1.Use wire connectors to connect the fan wires to the power supply wires according to the wiring diagram and the following
instructions (Figure 4.1):
• Connect the green wire from the mounting bracket to the bare/green (ground) supply wire.
• Connect the white wire from the fan to the white (neutral) supply wire.
• Connect the black wire from the fan to the black (hot) supply wire.
WARNING: After the connections have been made, the connected wires should be turned upward and pushed carefully up
into the outlet box. Place the Black and White wire connections on opposite sides of the outlet box.
2. Slide the top of the motor assembly over the mounting bracket, aligning the slotted holes in the top of the motor assembly
with the pre-loosened mounting bracket screws in the mounting bracket. Twist the motor assembly clockwise to lock. Then,
re-insert the mounting bracket screws and securely tighten all screws (Figure 4.2).
3. Insert blade through slot in the side of the motor assembly. Align the holes of one blade with three blade screw holes in
underside of the motor assembly. Secure with the three blade screws and blade washers. Repeat this step for the remaining
blades (Figure 4.3).
Black (Hot)
White (Neutral)
Bare/Green (Ground)
Wire Connector
WARNING: Do NOT wire a
fan to a wall control.
Figure 4.1
Braided Cable
Figure 3.2
Slotted Hole
Green
Figure 4.2
Open Loop
Secondary
Support Screw
Support
Washer
Spring
Washer
Mounting
Bracket Screw
EN I 6
Secondary Support Screw
Figure 3.3
Slot
Blade Washer
Blade Screw
Figure 4.3
Advertisement
Table of Contents
