Camera; Network - Parrot ANAFI USA User Manual

Note: By activating advanced RTH features, if you select return to Pilot or Custom
position, the drone might not be able to reach its destination in case of low battery.
Parrot will not be held responsible in case the drone lands in a different location.
Return position
Tap "RESET ALL SAFETY PREFERENCES" on the bottom of the page to reset preferences.

Camera

Camera preferences enable you to select camera options, both in photo and video modes.
Camera calibration
Auto record from take-off
Display overexposure
Anti-flickering
About correct horizon: only resort to the "Correct horizon" and the "Cameras alignment"
procedures if you notice your videos and photos are systematically tilted on the same side or
if your visible and thermal cameras are misaligned. Refer to the "Camera calibration" section
of this guide for the detailed procedure.
About Overexposure display: when this setting is activated, the HUD of FreeFlight 6 shows all
overexposed areas of the screen as hatched, which enables you to fine-tune your framing,
your EV settings, or both.
About Anti-flickering: this setting and the associated technology aim at eliminating the flicker
effect which can arise due to some artificial lights. The "AUTO" option should work for most
users, but depending on your country, you can try other settings if you feel bothered by a
flicker effect on your device's screen, your artificial light videos, or both.
Tap "RESET ALL CAMERA PREFERENCES AND SETTINGS" on the bottom of the page to reset
preferences.

Network

Network preferences let you change your
band.
- Broadcast DRI
- Network's name
- Password
- Wi-Fi band
About Direct Remote Identification (DRI): the DRI system makes your drone locally broadcast
information about itself for regulatory compliance (where applicable).
40
Tap "CALIBRATE" to access "Correct horizon", "Gimbal
calibration" and "Cameras alignment" features
NO / YES (video only)
NO / YES
NO / AUTO / 50Hz / 60Hz
OFF / ON
Tap the field to change your
Tap the field to change your network's password
AUTO / MANUAL
TAKE-OFF / PILOT / CUSTOM
's Wi-Fi network name, password, and
's network name