Advertisement
4. Connecting your scale.
Place your scale on a firm and flat surface near to your
computer.
Connect your scale to your computer using the USB cable
supplied. Then press the Zero button.
Note: If you do not wish to use a USB to connect your scale
refer to the online help for information on battery installation.
5. Connecting the printer.
Connect the power cord and adapter to your printer
(as shown) and switch on.
6. Printer ready.
Wait for approximately 45 seconds until the green
light remains constant and the printer is ready.
7. Aligning the label roll.
Press the
Note: If the label does not feed correctly please refer to label
alignment instructions inside the printer top cover.
Tear off the correctly dispensed label.
button and check that the label feeds out correctly.
Hold
Mode
Zero
Advertisement
