Table of Contents
Advertisement
INSTALLATION
6. Slide the second case up to the first case snugly. Then
align the second case to the first case so that the
glass, front bumper, bodywork, and top are flush.
7. To compress the sealant at the joints, use two
Jurgenson
or similar hand screw type wood clamps.
®
Make sure the case is level from front to back and side
to side per the instructions in step 1. If using clamps
on the plastic sprayed interior liner use scrap wood
(as wide as possible) under the clamps so that the
liner is not damaged. Be careful to observe the area
where the clamp is being tightened so that the case is
not damaged as pressure is applied.
8. Attach cases together via 2 bolts located in the end
leg tubes at the base of the cases and 1 bolt in the rear
raceway end brackets. On fixed glass Meat and Fish
cases, there are 2 additional bolts in the top of the
case that are accessible by removing the top insert.
The top insert is removed by pushing up on the bottom
side of the insert from inside of the case.
(Cont'd)
Bolt Locations
9. Remove the masking tape from the bulkheads only
and trial fit the stainless steel bulkhead caps. Once
proper fit is confirmed, apply a bead of silicone to
the tops of the bulkheads and install the stainless
steel bulkhead cap. Also, sparingly apply silicone to
seal case interior and exterior bodywork as needed
to ensure a water-tight seal, and a cleanable and
professional appearance. Use a finger in a clean
rag, as you go, to smooth the silicone as thin as
possible on the inside and outside of the case, while
it is still fluid. (Apply additional silicone if necessary).
Immediately remove the masking tape applied in step
3.
GLASS BREAKAGE MAY OCCUR!
Retighten glass along glass clamp after leveling
and FIRST time case is brought to FULL
Bolt
Loc.
Line Up
Pin
Line Up Tab
7
operating temperature!
Advertisement
Table of Contents
