INSTALLATION
Joint Trim
After cases have been levelled and joined, and refrigeration,
electrical, and waste piping work completed, install the splash
guards and joint trim where necessary. Fasten the splash
guards along the top edge, or center, with 3/8" long sheet
metal screws. If needed, use silicone sparingly to caulk
the joint trim and exterior body panels with an appropriate
colored silicone to ensure that a cleanable and professional
appearance is achieved. Use a finger in a clean rag, as you
go, to create smooth and neat joints, while the silicone is
still fluid.
Bumper Installation Instructions
Step 1: Make sure the aluminium channel and end caps
are installed.
Step 2: Use silicone lubricant to help the
bumper slide into the channel.
(Cont'd)
12
LEGEND
Grey Silicone
as needed
Joint Trim
Butyl Sealant
Bulkhead
Cap
Case Bolting
Step 3: Starting on one end: while inserting the bumper,
push it up against the end cap to prevent
the bumper from shrinking after installation
(when it gets cold).
Step 4: As you insert the bumper into the channel with
one hand, pull the bumper toward you with
the other to open the inside lips. Slowly
apply pressure by rolling the bumper into
the track.
Case Bolting
Bulkhead
Cap
Case
Bolting
Joint
Trim