Table of Contents
Advertisement
INSTALLATION
4. Apply masking tape 1/8" in from end of case on the inside
and outside rear mullion and to the side bulkheads on
both cases to be joined. The tape will minimize cleanup
from sealant overflow when the cases are drawn together.
(It can also be left in place on the upper case mullions and
exterior bodywork for finish caulking with silicone in step
9.)
5. Apply liberal beads of case joint sealant (butyl) to the
areas (solid dark lines) shown in the diagram below
(Fig.2, #1) of the first case.
It is the contractor's responsibility to install
case(s) according to local construction and
health codes
(Cont'd)
6
LEGEND
Grey Silicone
as needed
Joint Trim
Butyl Sealant
Bulkhead
Cap
DO NOT USE PLUMBERS PUTTY
Plumber's putty will not allow the cases to be fully drawn
together which will cause gaps between the cases resulting
in poor bodywork fit, finish and case sealing. Only use
Plumber's putty where necessary after the cases have
been bolted and drawn tightly together.
Case Bolting
Bulkhead
Cap
Case
Bolting
Case Bolting
Joint
Trim
Advertisement
Table of Contents
