Mac Filter - ZyXEL Communications NR2101 User Manual

Figure 58 WPS SETTINGS
The following table describes the labels in this screen.
Table 24 WPS SETTINGS
LABEL
WPS Enable
Via the WPS
button
WPS
Device PIN

7.4 MAC Filter

This screen allows you to configure the NR2101 to exclude specific devices from accessing the NR2101
(Deny listed stations). Every Ethernet device has a unique MAC (Media Access Control) address. The
MAC address is assigned at the factory and consists of six pairs of hexadecimal characters, for example,
00:A0:C5:00:00:02. You need to know the MAC addresses of the devices to configure this screen.
Use this screen to view your NR2101's MAC filter settings and add new MAC filter rules. Click MAC FILTER
and the screen appears as shown.
Chapter 7 WLAN & WWAN
DESCRIPTION
Click Enable to enable WPS on the NR2101.
Click this to activate WPS on the NR2101 via the WPS button.
Click this button to connect.
This field is available only when you set WPS Enable to Enable.
Enter the PIN Code of the device that you are setting up a WPS connection with, and then click
Connect to authenticate and add the wireless device to your wireless network.
You can find the PIN either on the outside of the device, or by checking the device's settings.
Note: You must also activate WPS on that device within two minutes to have it
present its PIN to the NR2101.
NR2101 User's Guide
67