What Are The Power Requirements For This Station; Setup: How Do I Setup My Station; Mounting: Where Do I Mount/Position My Sensors; Where To I Place My Station - La Crosse 328-1414BW Faqs

TX145R Rain Sensor
Transmission for both sensors is at 433MHz RF.

WHAT ARE THE POWER REQUIREMENTS FOR THIS STATION?

TX145WSDTHv2 or TX145WSDTHv3: 3 "AA" batteries
TX145R: 2 "AA" batteries
328-1414BW: 3 "AA" batteries
All batteries are sold separately.
1. Insert batteries into your sensors and station.
2. Enter Basic Settings.
3. Allow up to 10 minutes for sensors to connect.
4. Place your sensors outside in appropriate locations.

MOUNTING: WHERE DO I MOUNT/POSITION MY SENSORS?

TX145WSDTHv2 or TX145WSDTHv3 Breeze Sensor:
• Place your wind sensor two times higher than any large object within 50 feet. Wind does not
pass through hard objects, it is distorted by them. If your sensor is too close you will
measure the air turbulence and not actual wind speed.
• Place away from trees. Wind passing through trees moves slower than wind in open areas.
• Mount your sensor in a vertical position with the wind cups on top.
• Maximum transmission distance from your multi-sensor to your station, in open air is 400 feet
(121.92meters).
• Use the included mounting bracket or your own mounting pole (no more than 1 inch outer
diameter to fit). Secure to the sensor with screws provided. Tighten the screws to snug (do
not over tighten).
• Solar panel must face south to provide correct Wind Direction.
• General Wind Sensor mounting video:
TX145R:
• Mount the Rain Sensor horizontally and ensure its level.
• The sensor should be mounted more than 3 feet above ground.
• Your Rain sensor needs to be in an open area for accurate readings.
• Make sure the base of your Rain Sensor is not in a depression.
• This Rain Sensor has drainage holes in the bottom to allow it to self-empty.
• View sensor mounting video at:
Your station is designed for flexible placement on a desk or countertop, or to position on the
wall. When the stand is closed, it provides wall mounting holes.

SETUP: HOW DO I SETUP MY STATION?

http://bit.ly/wind_sensor_mounting
bit.ly/Rain_SensorMounting

WHERE TO I PLACE MY STATION?

3 | P a g e