Table of Contents
Advertisement
Optidew User's Manual
3.1.2
Customizable Readouts
The three readouts on the Main Screen can be configured by the User to show any
of the following parameters:
•
Dew Point
•
Temperature
•
Pressure
•
% Relative Humidity
•
g/m
3
•
g/kg
•
ppm
V
•
Twb
•
wvp (water vapor pressure)
•
Dew Point (pressure corrected)
To change a parameter:
1.
Touch the readout once to enable parameter selection
2.
Touch the left or right arrows to select the parameter to be displayed
3.
Touch the center of the readout to confirm selection
Full Screen Mode
Any of the readouts can be shown in full screen mode by touching and holding the
readout.
3.1.2.1 Locking the Analyzer
From firmware version 1.0.1 onwards it is possible to lock the analyzer so unauthorized
users cannot change any settings. Go to the SETUP page and in the bottom left
hand corner there is a padlock icon on that is greyed out. Pressing it will bring up
the passcode entry screen where you will need to enter 5491. The padlock icon will
become solid to show it is now activated.
After five minutes, this function will lock the analyzer (you will need to return to the
main screen). To unlock the screen you must enter 5491.
It is possible to deactivate the function before it is triggered or after activation by
simply pressing the solid padlock item in the Settings Menu.
Kahn Instruments
OPERATION
17
Advertisement
Table of Contents
