Safety Symbols; Environmental Conditions; Emc Information - UMF Medical FUSIONONE 3001 Owner's Manual

SAFETY SYMBOLS

WARNING:
The warning symbol identifies
special instructions or procedures,
which if not correctly followed
could result in personal injury.
This product has been evaluated
with respect to electrical shock,
fire, & mechanical hazards only,
in accordance with ANSI/AAMI
ES60601-1:A1:2012,C1:2009/
(R)2012 and A2:2010/(R)2012, CSA
CAN/CSA-C22.2 NO. 60601-1:14,
IEC 60601-1 Edition 3.1 (2012).
REFER TO OWNER'S MANUAL
DO NOT SIT

ENVIRONMENTAL CONDITIONS

TRANSPORT/STORAGE TEMPERATURE: -20ºC to 40ºC
TRANSPORT/STORAGE/OPERATING HUMIDITY: 95% maximum
OPERATING TEMPERATURE: 0ºC to 40ºC

EMC INFORMATION

1. This ME Equipment is intended for use in the professional healthcare setting.
2. WARNING: Use of this equipment adjacent to or stacked with other equipment should be
avoided because it could result in improper operation. If such use is necessary, this equipment
and the other equipment should be observed to verify that they are operating normally.
3. Maximum length of the power supply cable is not to exceed: 10 ft.
Maximum length of the hand/foot control cable is not to exceed: 10 ft.
4. WARNING: Use of accessories, transducers and cables other than those specified or provided
by the manufacturer of this equipment could result in increased electromagnetic emissions or
decreased electromagnetic immunity of this equipment and result in improper operation.
5. WARNING: Portable RF communications equipment (including peripherals such as antenna
cables and external antennas) should be used no closer than 30 cm (12 inches) to any part
of the [ME EQUIPMENT or ME SYSTEM], including cables specified by the manufacturer.
Otherwise, degradation of the performance of this equipment could result.
6. There are no maintenance requirements specifically related to EMC, all maintenance items
are addressed in the important information section
CAUTION:
The caution symbol identifies special
instructions or procedures, which if
not properly followed could result in
danger or damage to equipment.
CLASS II EQUIPMENT
ATTENTION, CONSULT
ACCOMPANYING DOCUMENTS
GENERAL WARNING
DO NOT STAND
TYPE B APPLIED PART
PROTECTIVE
EARTH GROUND
HOT SURFACE
3