Step 9- Rail End Assembly - Bernina Quilting Frame Assembly Instruction Manual

8-2: Screw (2) M6 x 45mm SBHCS
through the Left Frame End, Left Side Leg
Brace, and the Side Leg, as shown in Fig.
8-1.
8-3: Screw (1) M6 x 10mm SBHCS
through the Left Side Leg Brace and into
the Left Frame End.
8-4: Follow Step 8-1 through 8-3 for
the right side.
Step 9: Rail End Assembly
Parts Needed:
4- Rail Segments*
8- Ratchet Wheel Assembly (Pre-Installed)
Tool Required:
6mm Allen Wrench
*Note: If you set the frame up in Crib Size you will
need to make sure only (4) rails have a ratchet assembly
attached to each end of the rail. Make sure that all (8)
rails only have (1) ratchet assembly attached to each end if
you are setting your frame up in the King Size.
Note: The ratchet wheel assembly comes pre-installed. If setting your frame up in King Size, skip to
Step 12.
9-1: To remove the ratchet, loosen and completely remove the M10 screw using a 6mm Allen
Wrench.
9-2: Attach the removed ratchet wheel assembly to the end of (1) rail with a ratchet wheel attached,
as shown in Fig. 11-1.
9-3: Follow Step 9-1 thru 9-2 to complete the other (3) rails.
Left Frame End
M6 X 45mm
SBHCS
Left Leg Brace
M6 X 10mm
SBHCS
Pre-assembled
onto end of rail
Fig. 8-1
Rail
Fig. 9-1
Pg.9