Flex Ali 10.8 B Operating Instructions Manual page 16

Protect the battery charger from
humidity, rain, snow and frost.
Do not open the battery. Risk of short-
circuit!
Protect the battery from heat
(e.g. strong sunlight) and fire.
Risk of explosion!
Never short-circuit the battery.
Risk of explosion!
If the battery is damaged or used
improperly, fumes may escape.
Risk of damage to health! Supply fresh
air. If you feel unwell, call a doctor.
Damage to property!
The mains voltage must correspond
with the voltage information on the
rating plate of the battery charger.
Do not actuate the direction of rotation
selector (5) or torque setting (4) until the
tool is at a standstill.
Noise and Vibration
The noise and vibration values have been
determined in accordance with EN 60745.
ALi 10.8 B/ALi 10.8 S
The A-weighted sound pressure level of the
power tool is typically: sound pressure level
72 dB(A); sound power level 83 dB(A);
uncertainty K = 3 dB. Wear ear protection!
Total vibration values (vector sum in three
directions) determined in accordance with
EN 60745:
Screwing:
Vibration emission value a
uncertainty K = 1.5 m/s
ALi 10.8 G
The A-weighted sound pressure level of the
power tool is typically: sound pressure level
72 dB(A); sound power level 83 dB(A);
uncertainty K = 3 dB. Wear ear protection!
Total vibration values (vector sum in three
directions) determined in accordance with
EN 60745:
16
2
=1.25 m/s ,
h
2
.
ALi 10.8 B/ALi 10.8 G/ALi 10.8 S
Drilling in metal:
Vibration emission value a
uncertainty K = 1.5 m/s
Screwing:
Vibration emission value a
uncertainty K = 1.5 m/s
ALi 10.8 B/ALi 10.8 G/ALi 10.8 S
The vibration emission level given in this
information sheet has been measured
in accordance with a standardised test
given in EN 60745 and may be used
to compare one tool with another.
It may be used for a preliminary
assessment of exposure.
The declared vibration emission level
represents the main applications of the tool.
However if the tool is used for different
applications, with different accessories
or poorly maintained, the vibration emission
may differ. This may significantly increase
the exposure level over the total working
period.
An estimation of the level of exposure to
vibration should also take into account the
times when the tool is switched off or when
it is running but not actually doing the job.
This may significantly reduce the exposure
level over the total working period.
Identify additional safety measures
to protect the operator from the effects
of vibration such as: maintain the tool and
the accessories, keep the hands warm,
organisation of work patterns.
2
< 2.8 m/s ,
h
2
,
2
= 1.25 m/s ,
h
2
.