Wiring Connections; Typical Installation - Manrose FAN2120 Instructions

Through Roof Fan Cowls and Fan Kits

WIRING CONNECTIONS

For inline centrifugal fan models:
FAN2120 / FAN2122
P
N
E
White

TYPICAL INSTALLATION

Fasten tube to roof truss or rafter using clamp bracket supplied.
Tube/cowl must be mounted vertically to ensure weatherproofi ng
Flexible ducting connects directly to the
bottom of rigid duct. Cut any excess
length of ducting off before connecting.
NOTE
• The roof fl ashing supplied is not suitable for fi tting directly on to tiled roofs.
• As per the E2 Building Code, a roof soaker fl asher plate is required for roof penetrations greater than 60mm diameter.
Please refer to E2 Building Code for more details.
Installation Instructions
enquiry@manrose.co.nz | www.manrose.co.nz
Brown
Blue
Motor
Green/Yellow
Black
2.0 F
CAP
Fix diffuser to ceiling and fasten ducting. If screw-fi xing diffuser is
supplied cut 153mm diameter hole. If diffuser is type with spring
loaded self-latching clip fasteners cut 205mm diameter hole.
Specifi cations are subject to change without notice
For inline high performance centrifugal fan models:
FAN2121 / FAN2123
P
N
E
White
Make electrical connections below roof
Black
Blue
Motor
Green/Yellow
Brown
2.0 F
CAP
Page 3
Distributed by Simx Limited