Gorenje CM06BK Instruction Manual page 7

This equipment is labelled in compliance
with the European Directive 2012/19/EC on
waste electric and electronic equipment
WEEE. The Directive specifies the
requirements for collection and
management of waste electric and
electronic equipment effective in the entire
European Union.
Before using the appliance for the
first time
For the perfect flavour, run the coffee
brewing cycle with water only (without
coffee) two or three times. Each time the
water runs through the appliance, unplug it
and let it cool down for five minutes. Then
repeat the cycle with fresh water.
Brewing coffee
1. Open the water tank lid and fill the water
tank with cold drinking water. The water
level should not exceed the MAX level as
indicated on water gauge.
2. Swing the funnel holder out, put the
funnel into funnel holder, then place the
filter paper in the funnel, and make sure
it is assembled correctly.
3. Add ground coffee into the paper filter.
Usually a cup of coffee needs a level
spoon of ground coffee, but you may
adjust the amount according to personal
taste. Close the funnel holder. A click
sound will be heard when the funnel
holder is closed completely.
4. Place the carafe on warming plate
horizontally.
5. Plug the power cord into the outlet.
6. When you press down the switch, the
indicator will be illuminated. The
appliance will begin operating.
Note 1: During brewing process, you may
remove the carafe to serve the coffee for
up to 30 seconds; during this time, the
coffee maker will stop dripping
automatically. If the serving time exceeds
30 seconds, the coffee will overflow the
funnel.
Caution: DO NOT touch the cover while
the unit is brewing coffee, to avoid being
scalded by hot steam.
7. When the brewing process is complete –
i.e. one minute later after the coffee
stops dripping out – you may remove the
carafe and serve the coffee.
–
Note: The amount of brewed coffee you
get will be slightly less than the amount
of water you added, since some water is
absorbed by coffee grounds. During
operation, DO NOT touch the cover,
warming plate and other parts, as they
are very hot.
8. If you do not wish to serve the coffee
immediately after the brewing process is
finished, keep the switch on, and the
coffee can be kept warm on the warming
plate for 40 minutes. After this time, the
appliance will be switched off
automatically. For optimum coffee taste,
serve it immediately after brewing.
9. Always switch off the coffee maker and
disconnect it from power supply after
use.
Note: Be careful when pouring the
coffee. The coffee that has just been
brewed is very hot and you could scald
yourself.
Cleaning
CAUTION: Always unplug the appliance
from the electrical outlet and allow the
warming plate to cool completely before
cleaning it. Never immerse the unit or the
power cord in water or any other liquid for
cleaning.
1. Clean all detachable parts after each use
in hot sudsy water.
2. Wipe the product's exterior surface with a
soft damp cloth to remove stains.
3. Water droplets may build up in the area
above the funnel and drip onto the coffee
maker base during brewing. To control
the dripping, wipe off the area with a
clean dry cloth after each use.
4. Use a damp cloth to gently wipe the
warming plate. Never use an abrasive
cleaner to clean it.
5. Replace all parts and store until next use.
Removing mineral deposits
To keep your coffee maker operating
efficiently, you should periodically clean the
mineral deposits, the build-up of which
depends on water quality in your area and
6