Required Tools And Materials; Decommissioning And Disposal - Siemens SIMATIC NET RUGGEDCOM MX5000 Installation Manual

Introduction
1.3 Required Tools and Materials
Utility USB Port
Compact Flash Card Port
RS232 Serial Console Port
Failsafe Alarm Relay
Power Supply Terminal Block
1.3

Required Tools and Materials

The following tools and materials are required to install the RUGGEDCOM MX5000:
AC or DC power cord (16 AWG)
CAT-5 Ethernet cables
Phillips screwdriver
4 x #8-32 screws
1.4

Decommissioning and Disposal

Proper decommissioning and disposal of this device is important to prevent malicious
users from obtaining proprietary information and to protect the environment.
Decommissioning
This device may include sensitive, proprietary data. Before taking the device out of
service, either permanently or for maintenance by a third-party, make sure it has
been fully decommissioned.
For more information, refer to the associated Configuration Manual.
Recycling and Disposal
For environmentally friendly recycling and disposal of this device and related
accessories, contact a facility certified to dispose of waste electrical and electronic
4
Use the USB port to upgrade the RUGGEDCOM RUGGEDCOM
MX5000 software or install files, such as configuration files and
feature key files. For more information, refer to the RUGGEDCOM
ROX Configuration Manual for the RUGGEDCOM MX5000.
Houses the CompactFlash (CF) card that contains active and backup
installations of RUGGEDCOM RUGGEDCOM MX5000, along with
the configuration database and other system data. For more
information, refer to
20)".
The serial console port is for interfacing directly with the device
and accessing initial management functions. For information
about connecting to the device via the serial console port, refer to
"Connecting to the Device (Page
Latches to default state when a power disruption or other alarm
condition occurs. For more information, refer to:
• "Connecting the Failsafe Alarm Relay (Page 14)"
• "Failsafe Relay Specifications (Page 35)"
A pluggable terminal block. For more information, refer to
"Connecting Power (Page
Tools/Materials
"Accessing the CompactFlash Card (Page
19)".
15)".
Purpose
For connecting power to the device.
For connecting the device to the network.
For mounting the device to a panel.
For mounting the device to a panel.
Installation Manual, 01/2021, C79000-G8976-1059-13
RUGGEDCOM MX5000