.1.1.1. ACtIvAtIoN ANd ReAsseMBLy of the QUICK ReLeAse At the
depoWeRLoop
You can activate the FLYSURFER Safety System while using the Quick Release at the Depower-
loop or unhooking it by hand and not holding to the bar.
To activate the Quick Release pull the red ball at the Depowerloop towards your body.
This motion sequence should be trained blindly and with both hands.
Assembly:
Guide the white line called Half-Force line through the blue end of the depowerloop and
afterwards through the blue loop on the crossbar.Now push in the metal pin from the outside,
first through the white Half-Force line and than into the guide pocket on the crossbar.
Please check the reassembled depowerloop before you hook in and launch.
10
Try a test deployment just to be sure
you put the loop back together
properly.
We suggest to try it a few times be-
fore you go into the water.
Need help?
Do you have a question about the Speed 2 and is the answer not in the manual?