Alesis Data Disk Reference Manual page 64

3) Press the
been received to store the data into a file.
received for 1 minute, the DataDisk will automatically store the
received data into a file. If either SCROLL button is pressed before
the minute is up, the sequence data WILL NOT BE STORED ON
DISK.
When a file is stored the display will read:
The manufacturer and product names will be displayed as "MIDI Seqnce"
(similar to sample dump) and the file name will default to "File ZZ" where
ZZ is an automatically assigned number.
NOTE: If additional MIDI messages are received, the display will
automatically revert to the Receiving Sequence display. Therefore, it's
best to stop the sending sequencer first before pressing the
to store the sequence.
If, while receiving a sequence, you decide that you wish to abort the
operation, press either of the
4) To exit this display, press any function button.
PLEASE NOTE:
MIDI Echo (MIDI Thru) function is ignored when in the Receive MIDI
Sequence mode.
When recording to a sequencer from the DataDisk, keep in mind that
the incoming data is subject to the quantize resolution that the sequencer
is currently set at.
handshaking, do not echo data being sent from the DataDisk through a
sequencer and back into the DataDisk. If this is done, the sequencer will
crash and most likely lose all of its data.
Receiving Seq. . .
File Complete?
button when all desired MIDI data has
DO/YES
STORED AS MIDI
Seqnce FILE ZZ
buttons. The display will then read:
SCROLL
OPERATION
ABORTED
c) In
If no MIDI data is
DO/YES
a)
all circumstances
59
APPENDIX
button
The
b)
of