D Copy Song - Alesis BRC Reference Manual

2. Press the LOCATE SONG button again to rewind or fast forward to
the currently displayed song start address.
The REW or FFW LED will flash depending on the direction of the
search.
Note: If the LOCATE SONG function is initiated while in record,
recording will be stopped (punched out) before performing the
locate.

4.6D Copy Song

So let's say you're working on a session doing multiple takes of the
same song. Many of the same functions will be used for each take,
like locator points, Pre/Post-Roll times, Auto-Group Record, etc. Once
you have setup the parameters for the first song, you can copy the
information as many times as you have songs to record. This can
greatly minimize setup time. When you set each song to begin at a
different start position before copying, the locate points of each song
are offset to retain their relative positions.
The COPY SONG button is used to copy the settings of the current
song to another existing song.
To copy the current song:
1. Locate the song you wish to copy (see section 4.6C);
2. Press the COPY SONG button;
The display will show:
COPY TO SONG X X?
(Press RECORD)
...where XX is the song number range 01 through highest existing
song number (max. 20). It defaults to one number higher then the
current song number. So if you had located song 03, the display
would now read song 04. If the current song number is 20, than this
value will default to the current song.
3. Use the UP/DOWN buttons to select the desired song location to
copy the current song data to;
4. Press RECORD to execute the operation.
61