C Locate Song - Alesis BRC Reference Manual

1. If the LCD display is not currently displaying the Set Song page,
press the SET SONG button;
2. Press the NAME button to move the cursor to the first character in
the song's name;
3. Use the Cursor buttons to position the cursor beneath the
character you wish to edit;
4. Use the Numeric Keypad or the UP/DOWN buttons to change the
name as desired (see sections 1.4F and 1.4G);
5. Press the NAME button again when finished.

4.6C Locate Song

The LOCATE SONG button is used to rewind or fast forward the
tape(s) to a song's start location. Locating a song also recalls its locate
points, Pre/Post-Roll times, Loop points, Auto-Punch points, etc.
However, you do not physically have to locate to the song's position
to recall its parameters. By going into the Locate Song page and
selecting a song, its parameters are immediately recalled. The song
number or start address can be edited before initiating the locate.
To locate a song:
1. If you are not already in the Set Song display or Locate Song
display, press the LOCATE SONG button;
The Locate Song page reads as follows:
S X X "SongName "
...where XX is the current song number (01 through 20), SongName is
a 10-character song name and hh:mm:ss:ff is the song's start address.
The address is displayed according to the type of Display Type you
have selected. If in NORMAL mode, the display will read 00:00:00
(minutes:seconds:frames). If in SMPTE mode, the display will read
00:00:00:00 (hours:minutes:seconds:frames); if in BAR mode, the
display will read 01–01/00 (bars:beats:sub-beats).
All the edit functions described regarding Set Song (including start
position, SMPTE offset, and song name) are also available within the
Locate Song display (see section 4.6A and 4.6B).
hh:mm:ss:ff
60