Track Copy; Display Brightness - Alesis ADAT-XT20 Reference Manual

T
RACK
It is possible to copy the audio material from one track to another on the same
tape within the XT20 without leaving the digital domain and without the
need for any audio cables. In fact, you can copy up to 4 tracks at a time using the
Track Copy feature. For more information on using the Track Copy function, see
page 44.
To bounce audio from one track to another:
The TRK COPY icon will light in the display.
pressing any of the RECORD ENABLE buttons [1]–{8].
The INPUT LEDs for the selected track(s) will light. Note: You can't select a
track that is already in record-ready (REC LED lit) as a source track; if its
RECORD ENABLE is pressed, its INPUT LED won't light while holding the
[TRACK COPY] button.
pressing one of the RECORD ENABLE buttons [1]–[8].
The REC LEDs for the selected track(s) will light. Note: You cannot select a
source track as a destination track; if its RECORD ENABLE is pressed, its R E C
LED won't light.
9] buttons to move to the section of tape which holds the audio you wish to
copy.
The [RECORD] and [PLAY] LEDs will light and recording will begin.
The [STOP] LED will light and the transport will stop.
While the TRK COPY icon is lit (indicating that Track Copy mode is
selected) you will not be able to record any audio being fed to the analog or
digital inputs. To record from the analog inputs, you must press the [ANALOG
INPUT] button (the ANALOG icon will light in the display).
D
ISPLAY
If necessary, the brightness of the XT20's display may be adjusted to allow more
suitable viewing under various lighting conditions.
To adjust the display brightness:
dim or brighten.
The display will immediately respond by either dimming or brightening,
depending on which button was pressed.
ADAT XT20 Reference Manual
C
OPY
Press and hold [TRACK COPY].
While holding [TRACK COPY], select a source track (up to 4) by
Release [TRACK COPY], and choose a destination track (up to 4) by
Use the [REWIND], [FAST FWD] or [LOCATE 0] through [LOCATE
Simultaneously press [RECORD] and [PLAY] to initiate recording.
When you are finished, press [STOP].
B
RIGHTNESS
Hold the [PEAK CLEAR] button.
While still holding [PEAK CLEAR], press either PITCH [ ] or [ ] to
Your First Session With The ADAT XT20: Chapter 2
31