Husqvarna K4000 Workshop Manual page 43

4. Put the wrench as in the illustration. Push out or hit
the bearing with a socket.
5. The bushing is put with a force fit. To remove it, put
it out from the edge of a wooden block. Put the used
bearing on the holder and hit it until there is a space
between it and the cutting arm.
6. Remove the bushing with a screwdriver.
474 - 002 - 27.06.2018
6.11.3.2 To install the bearing Cut-n-Break
To install the bearing, use Husqvarna wrench.
Servicing tools overview on page 12
See
1. To put the new bearing, use a press. Apply press
force to the outer ring of the bearing. You can also
put the bearing with a vice. Put the bearing cage in
the Husqvarna wrench.
2. Use a press to put the bushing. You can also use a
small plastic mallet.
Repair and servicing - 43