Carbon Brush Holders - Husqvarna K4000 Workshop Manual

6.1.3 To install the carbon brushes
1. Clean the holder.
2. Install the new carbon brushes.
3. Install the cable lug and tighten the screw.
4. Install the inspection cover and screws.
You must break in new carbon brushes. Run the
machine for 30 minutes without a load.
474 - 002 - 27.06.2018

6.2 Carbon brush holders

6.2.1 To remove the carbon brush holders
1. Remove the brushes. See
brushes on page 16
2. Remove the screws to the right handle.
3. Remove the right handle.
To remove the carbon
Repair and servicing - 17