Husqvarna K4000 Workshop Manual page 35

Note: The nut must be loosened in a clockwise
direction.
12. Remove the drive pinion and the spacer.
13. Put the rotor in a vice with soft jaw guards.
14. Put a metal object against one corner of the gear
housing. Apply force as in the illustration. Use a
plastic hammer on the opposite side. If necessary,
change position of the metal object and use the
hammer again on the opposite side.
6.9.2 To remove the gear housing bearing
To remove the gear housing, see
gear housing on page 33 . To remove the bearing, use a
counter stay device and an internal bearing extractor. As
474 - 002 - 27.06.2018
To disassemble the
an alternative to the counter stay device you can use a
Servicing tools overview on page 12
slide hammer.
1. Remove the circlip.
2. Remove the bearing with a counter stay device or a
slide hammer. If necessary, use a hot air gun around
the bearing to decrease the press force.
3. Remove the felt seal and the washers.
Repair and servicing - 35