Blade Guard - Husqvarna K4000 Workshop Manual

8. To apply grease, use Husqvarna grease, 25g. See
Servicing tools overview on page 12 . Do not use
other types of grease. Apply it to the drive pinion and
fill the needle bearing.
9. Put the crown gear unit and new gasket.
10. Tighten the four screws with a torque of 10-12 Nm.
38 - Repair and servicing

6.10 Blade guard

6.10.1 To remove the blade guard
1. Remove the center bolt, washers, spacer and plastic
seal.
2. Remove the screws and the washer that hold the
blade guard against the bearing housing.
474 - 002 - 27.06.2018