Husqvarna K4000 Workshop Manual page 37

6.9.6 To install the gear housing
1. Push the rotor in to the gear housing.
2. Push the spacer and the drive pinion onto the shaft.
3. Tighten the nut.
Note: The nut must be tightened in an
counterclockwise direction. The tightening torque
must be 33-35 Nm. Use a torque wrench with a u-
grip since there is not space for a socket.
474 - 002 - 27.06.2018
!
4. Put the gear housing and the rotor half into the
motor housing.
5. Tighten the screw for the ground wire from the motor
housing.
6. Put the gear housing and rotor.
7. Tighten the four screws to the gear housing.
Repair and servicing - 37