Linkam Scientific Instruments THMS600 User Manual page 30

The circular end of the sample holder will go up
the Sample Holder Ramp (1) ramp and rest on
surface of the silver block.
1
Place a 7mm W7S sapphire or a W7Q quartz
window (2) using the vacuum tweezers onto the
surface of the silver block next to the end of the
sample holder.
2
With one hand carefully lift the G7T about 1mm
off the silver heating block and slide the 7mm
sample window directly underneath the circular
sample holder. Release G7T and it should clip
the sample window into place.
Adjust the XY-manipulators by a few turns in
both directions to make sure the 7mm sample
window is fitted securely in place.
Now load the sample onto the top of the sample
window.
30