Replacing Light Bulbs; To Manually Start The Generator; Automatic Generator Start (Ags) - Jayco Swift Owner's Manual

To Manually Start the Generator

Manual switches located on the generator.
1. At either "START/STOP" switch, press and hold the upper portion of the switch to
start the generator. Depending on the outside temperature the start process can take up
to 15 seconds. Once the generator starts running, release the "START/STOP" switch.
2. An LED above the start switch will light when the generator is running.
3. For better performance and engine life, especially in colder weather, let the generator
engine warm up for two minutes before turning "ON" 120-volt appliances.
For more information on generator operation and maintenance, refer to the manufacturer's
owner's manual.
Automatic Generator Start (AGS) (if so equipped)
Certain models of motorhomes may be equipped with an Automatic Generator Start system
(AGS). The controls are built into the Firefly touchscreen system. When enabled, the Auto-
matic Generator Start system will automatically start and stop the generator.

Replacing Light Bulbs

Before replacing a bulb, be sure the light is off.
Replacement light bulbs must be of the type, voltage and wattage listed on the lamp fixture.
Use of incorrectly sized bulbs can overload lamp circuits and may create a fire hazard by
overheating the fixture.
Maintenance Record
Section 6: Electrical System
Table of Contents 55