Smoke Alarm - Jayco Swift Owner's Manual

Section 2: Occupant Safety
NOTE: For information on how to use your fire extinguisher, refer to the
fire extinguisher user's manual included in your warranty packet.
Inspection and maintenance
Read and follow all instructions on the label and user's manual provided by the fire extin-
guisher manufacturer.
Inspect the extinguisher at least once a week (more frequently if it is exposed to
weather or possible tampering). This should also be done before beginning a va-
cation or during an extended trip.
Do not check the pressure, test or practice using the fire extinguisher by
squeezing the trigger, even briefly. The fire extinguisher is not rechargeable or
refillable. Once used, it will gradually lose pressure and will not be fully
charged for use in an emergency.
Do not turn the electrical power back on or plug in any appliances after the use
of a fire extinguisher. Please refer to the fire extinguisher's user manual for
further instructions on maintenance and clean up.

Smoke Alarm

The smoke alarm will only work properly if it is opera-
tional and maintained. They have a limited life and will
wear out over time. Immediately replace the detector if it
is not working properly, if it displays any type of problem,
or within five years of use. Be sure to read, understand
and follow the information provided by the smoke alarm
manufacturer, including information on the limited life
of smoke alarms.
Be aware the smoke alarm is not fool proof and cannot
detect fires if smoke does not reach it. Anything prevent-
ing smoke from reaching the alarm may delay or prevent an
alarm.
Though the alarm horn in this detector meets or exceeds current UL standards, it may not
be heard for reasons that include (but not limited to): a closed or partially closed door, other
noise from electronics, appliances or traffic.
Maintenance Record
16
Table of Contents