RadonAway AIRaider 433-S50 Instruction & Installation Manual page 5

1
1.3. Unpacking and Locating System Components
1.3.1. Unpack All System Components
Remove all packing material and discard appropriately away from the work area.
1.3.2. Locate All Components
Check to ensure all components are intact and included in shipment.(See Figure 5 and 8)
Included component list (may vary with order):
• Tank Assembly with Solenoid Assembly
• Control Panel* and Float Switches
• Submersible Pump**
• Jet Pump and Bladder Tank Assembly***
• Brass – Bypass Assembly, Pump Brass, and Tank Brass****
• Installation Kit – Manual, Pressure Gauge, etc.
* Model 321 does not come equipped with a control panel
** Mounted internally on 433-S50 and 433-S75 Systems, not supplied with 433 and 321 Systems.
*** Pump packages are sold separately on 321 and 433 Systems, and will vary with the order.
Bladder Tanks are sold separately.
**** Sold separately on 321 and 433 Systems. Standard systems are equipped for a ¾"
plumbing connection. 1" plumbing connection is available on 433 Systems only (Not 433
433-S50 or 433-S75). Please specify plumbing connection requirements when ordering.
Bypass Assembly is integral on 433-S50 Systems Only.
1.4. Use Qualified Technicians
A Licensed Plumber, Electrician, Contractor and/or Certified Water Treatment Specialist may be
required to install the AIRaider
must be performed in accordance with the National Fire Protection Association's (NFPA)"National
Electrical Code, Standard #70"-current edition for all commercial and industrial work. All wiring
must be performed by a qualified and licensed electrician. Check your Local and State Code and
Licensing requirements. Failure to follow the instructions may lead to poor system performance and/
or possible system damage.
The Installation must comply with all applicable Local and State Codes and
1.5. Full Water Test
A full Water Sample Analysis must be performed to determine the quality of the water that requires
treatment. In many water supplies, contaminants other than radon are present and may need to be
pre-treated in order for the AIRaider
the removal of radon and some other VOC's. The Aeration Process employed by the AIRaider
System and other radon removal systems can worsen problems due to iron or manganese contaminants in
the water supply. For optimal removal of radon or other VOC's, other contaminants such as iron or
manganese must be removed before the water supply enters the AIRaider
a sediment filter is highly recommended as a pre-treatment of the water supply. The filter should
be routinely cleaned or replaced.
FAILURE TO REMOVE OTHER CONTAMINANTS INCLUDING SEDIMENT CAN REDUCE
SYSTEM EFFECTIVENESS AND MAY RESULT IN SYSTEM DAMAGE , COMPONENT MALFUNCTION,
IN063 Rev.D 0120
PRE-INSTALLATION
System in accordance with the installation instructions. All wiring
TM
NFPA National Electrical Code, Standard #70!
to work properly. The AIRaider
TM
PROPERTY DAMAGE, AND PERSONAL INJURY.
3 Saber Way, Ward Hill, MA 01835 | radonaway.com
System is only effective for
TM
System. Installation of
TM
Page 5 of 22
TM