RadonAway AIRaider 433-S50 Instruction & Installation Manual page 15

1 2
2.6 Install Air Filter (Fig. 11)
1. Install air filter provided using the PVC pipe and fittings provided
(Fig 14).
2.6.1 Remote Air Intake (Fig. 12)
If a Remote Air Intake is required because of Air Quality or Quantity
issues then Use Only 1-¼" or larger Schedule 40 PVC or equivalent pipe
for the air intake line.
1. Connect air intake line to the blower using the proper reducer
coupling.
2. Run the intake line from the pipe connection on the blower to
the location selected for air intake.
Note: A rubber coupling or similar means to disconnect the intake line from
the is recommended.
3. Connect the Air Filter to the vent line using the proper
reducer coupling.
If the air intake is located outside, the filter or intake must be
mounted high enough off the ground to prevent the drawing in
of snow, water and other contaminants. Do not locate the air
intake in the vicinity of vents from furnaces, barbecue grills, etc.
Note: In-Line Air Filters are also available from the Manufacturer.
IN063 Rev.D 0120
INSTALLATION INSTRUCTIONS
3 Saber Way, Ward Hill, MA 01835 | radonaway.com
Figure 11
Air Filter
Figure 12
Air Intake Connection
Page 15 of 22