Codec Jacks; Table 2-19 Dsp56824Adm J4 Line In Description; Table 2-20 Dsp56824Adm J5 Line Out Description - Motorola DSP56824ADM User Manual

DSP56824ADM Technical Summary
DSP56824ADM Connector Descriptions
Table 2-18 DSP56824ADM J3 JTAG/OnCE Description
2.7.4

Codec Jacks

J4 and J5 are stereo jacks that allow the user to send and receive analog signals to and
from the on-board codec. J4 enables the user to apply an input signal to the on-board
codec. The pinout of this connector is listed in Table 2-19.

Table 2-19 DSP56824ADM J4 Line In Description

J5 enables the user to send an output signal from the on board codec. The pinout of this
connector is listed in Table 2-20.

Table 2-20 DSP56824ADM J5 Line Out Description

Note: J4 and J5 are stereo jacks. However, only mono audio capability is provided on
the DSP56824ADM.
2-22
Pin # Signal
9 J_RESET
11 V
CC
13 TRST/DE
Connector
Barrel
Tip
Ring
Connector
Barrel
Tip
Ring
DSP56824ADM User's Manual
J3
Pin # Signal
10 TMS
12
14 TRST/DE
Signal
ANALOG GND
LINE IN
LINE IN (optional)
Signal
ANALOG GND
LINE OUT
LINE OUT (optional)
NC
MOTOROLA