Installation - Microsensor MPM Series Operation Manual

Note:
1.MPM484ZL has no"AL-6" to"AL-8F"; MPM484C has no"AL-6"to"AL-8F","F--L" and
deputy display. All the information will be shown on main display if it has no deputy
display;
2.Baud rate: 0/1200,1/2400,2/4800,3/9600,4/19200,5/38400,6/57600,7/115200;
3.Relay property: "0" indicates the lower limit alarm, "1" indicates upper limit alarm;
4. "Zero output display" and "span output display" Used to adjust the output analog
quantity, The default is consistent with "zero display" and "full display";
5. "Common hysterisis" : it is used to eliminate the jitter of pressure at the critical
point of limit value, and the default value is 0;
6. "Second screen display": 0(default) Display "U--U"; 1~5(484ZL)/1~8(460) display
the corresponding limit value, 6 and 7(484ZL)/ 9 and 10 (460) display the zero
display and full span value;
7."Return factory" : set "1" and press the "confirm" button, the meter will immediately
restore the factory Settings, the default is "0" FAct indicates menu entering, "1"
means "restore to factory". Default is "0".

7. Installation

7.1 MPM484C, MPM460, MPM484ZL
The pressure port for MPM484C, MPM460, MPM484ZL controllers is
M20x1.5 male waterline seal. For flush diaphragm transmitting controller,
pressure port is G1/2 male with seal cushion. The controller could be
installed to flange connector on measuring tube directly. Please add
13